Don’t worry, the pieces are so small that it won’t make the wood art look asymmetric. Rather than trying to cut two tiny pieces to fill that space, cut the 1×2 at a 90-degree angle. Note: you might have 4 very small gaps along the edges at the end. When you find a size that works well and minimizes waste for a particular piece, cut 8 of them and place them on your plywood where they belong. We will trim the excess with the circular saw later. These don’t have to be cut exactly to size yet. I started by making the center “x” all a dark colors, then I tried to alternate light/dark without it being a consistent pattern. Label which stain colors you will use on each piece. Don’t be discouraged when you start placing all of your 1x2s on the plywood and they don’t align exactly with your drawing! STEP 3: decide on stain colors ![]() Note: tracing the sides of your 1x2s will result in drawings that are larger than your 1×2, but it will give you a great guide and understanding on how many pieces you need. Keep tracing the 1×2, lining up the angled side with the vertical and horizontal lines and the side of your 1×2 with the traced line you just drew. Trace either side of the 1×2 using your pencil. Line the angled edge of the 1×2 up with your vertical line. ![]() Step 2: draw your designĬut the end of a 1×2 at a 45-degree angle. Make sure to double-check your measurements! Our plywood wasn’t actually square. ![]() New to DIY? Download our free 5 Steps to Getting Start with DIY guide! Step 1: mark your plywoodĭraw two lines on your plywood: one marking the halfway distance vertically and one marking the halfway distance horizontally.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |